9V Battery Snap Connector clip
- Faux Leather Shell 2 Wired Connector
- Cable length : 14.5cm
- Wire Gauge: Typically 22 AWG or 24 AWG
Search Results for: 9V Battery
How to make a simple DIY 9v battery power car at home
Hello, welcome back. In this tutorial, we will learn how to make a simple DIY 9v battery power car at home. This creation is mainly based…
Lithium Battery Capacity Charge Indicator Tester
- Battery-type electricity quantity display
- Wide application fields: lithium battery
- Using Method: Connect display board positive and negative ports with tested battery positive and negative ports, the digital tube will display real-time battery electricity quantity
5V 1A Boost Step Up Power Module | Lithium LiPo Battery Charging Protection Board
- Input voltage: 3.7V~5.5V
- Charging current: Z greater than 1A
- Output current: Z greater than 1A
- Output voltage: 5V
- BAT discharge termination voltage: 2.9V
How to Make an Angle Detection Box Using Arduino Nano and Tilt Sensor | Step by Step
Hello and welcome back! In this project, we will learn how to make a DIY angle detection box using Arduino Nano. The main part of this…
How to use a water level sensor with the Microbit board
Hello and welcome back! In this tutorial, we will learn how to use a water level sensor with the Microbit board. For this project, I’ve used…
How to make a smart irrigation system with ESP32 DEVKIT V1 board and Blynk
Hello and welcome back. In this project, we will learn how to make a smart irrigation system with ESP32 DEVKIT V1 board. For this project, I…
How to make a Voice-Controlled Room Light with ESP32 DEVKIT V1 and Bluetooth | Step by step Guide
Hello and welcome back. In this project, we will learn how to make a voice-controlled room lighting system using the ESP32 DEVKIT V1 board. We have…
How to use the DHT11 sensor module with Micro:bit board | Micro:bit with Temperature and Humidity
Hello and welcome back. In this tutorial, we will learn how to use the DHT11 sensor module with the Micro: bit V2 board. This sensor can…